The Multicast Source Discovery Protocol (MSDP) router must be configured to use its loopback address as the source address when originating MSDP traffic.

Overview

Finding ID	Version	Rule ID	IA Controls	Severity
V-207182	SRG-NET-000512-RTR-000011	SV-207182r604135_rule		Low

Description

Using a loopback address as the source address offers a multitude of uses for security, access, management, and scalability of MSDP routers. It is easier to construct appropriate ingress filters for router management plane traffic destined to the network management subnet since the source addresses will be from the range used for loopback interfaces instead of a larger range of addresses used for physical interfaces. Log information recorded by authentication and syslog servers will record the router’s loopback address instead of the numerous physical interface addresses.

STIG	Date
Router Security Requirements Guide	2024-05-28

Details

Check Text (C-7443r382634_chk)

Review the router configuration to verify that a loopback address has been configured.

Verify that a loopback interface is used as the source address for all MSDP packets generated by the router.

If the router does not use its loopback address as the source address when originating MSDP traffic, this is a finding.

Fix Text (F-7443r382635_fix)

Ensure that the router’s loopback address is used as the source address when originating traffic.