The Cisco multicast Rendezvous Point (RP) router must be configured to filter Protocol Independent Multicast (PIM) Register messages received from the Designated Router (DR) for any undesirable multicast groups and sources.
Overview
| Finding ID | Version | Rule ID | IA Controls | Severity |
| V-216626 | CISC-RT-000830 | SV-216626r531085_rule | Low |
| Description |
| Real-time multicast traffic can entail multiple large flows of data. An attacker can flood a network segment with multicast packets, over-using the available bandwidth and thereby creating a denial-of-service (DoS) condition. Hence, it is imperative that register messages are accepted only for authorized multicast groups and sources. |
| STIG | Date |
| Cisco IOS Router RTR Security Technical Implementation Guide | 2024-11-25 |
Details
| Check Text (C-17861r287247_chk) |
| Verify that the RP router is configured to filter PIM register messages. The example below will deny any multicast streams for groups 239.5.0.0/16 and allow from only sources 10.1.2.6 and 10.1.2.7. ip pim rp-address 10.1.12.3 ip pim accept-register list PIM_REGISTER_FILTER … … … ip access-list extended PIM_REGISTER_FILTER deny ip any 239.5.0.0 0.0.255.255 permit ip host 10.1.2.6 any permit ip host 10.1.2.7 any deny ip any any If the RP router peering with PIM-SM routers is not configured with a policy to block registration messages for any undesirable multicast groups and sources, this is a finding. |
| Fix Text (F-17857r287248_fix) |
| Configure the router to filter PIM register messages received from a multicast DR for any undesirable multicast groups and sources. The example below will deny any multicast streams for groups 239.5.0.0/16 and allow from only sources 10.1.2.6 and 10.1.2.7. R2(config)#ip access-list extended PIM_REGISTER_FILTER R2(config-ext-nacl)#deny ip any 239.5.0.0 0.0.255.255 R2(config-ext-nacl)#permit ip host 10.1.2.6 any R2(config-ext-nacl)#permit ip host 10.1.2.7 any R2(config-ext-nacl)#deny ip any any R2(config-ext-nacl)#exit R2(config)#ip pim accept-register list PIM_REGISTER_FILTER R2(config)#end |