Changes are coming to https://stigviewer.com.
Take our survey to help us understand your usage and how we can better serve you in the future.
Take Survey
RHEL 8 must not be performing packet forwarding unless the system is a router.
Overview
| Finding ID | Version | Rule ID | IA Controls | Severity |
|---|---|---|---|---|
| V-230540 | RHEL-08-040260 | SV-230540r627750_rule | Medium |
| Description |
|---|
| Routing protocol daemons are typically used on routers to exchange network topology information with other routers. If this software is used when not required, system network information may be unnecessarily transmitted across the network. |
| STIG | Date |
|---|---|
| Red Hat Enterprise Linux 8 Security Technical Implementation Guide | 2021-06-14 |
Details
| Check Text ( C-33209r568366_chk ) |
|---|
| Verify RHEL 8 is not performing packet forwarding, unless the system is a router. Note: If either IPv4 or IPv6 is disabled on the system, this requirement only applies to the active internet protocol version. Check to see if IP forwarding is enabled using the following commands: $ sudo sysctl net.ipv4.ip_forward net.ipv4.ip_forward = 0 $ sudo sysctl net.ipv6.conf.all.forwarding net.ipv6.conf.all.forwarding = 0 If IP forwarding value is not "0" and is not documented with the Information System Security Officer (ISSO) as an operational requirement, this is a finding. |
| Fix Text (F-33184r568367_fix) |
|---|
| Configure RHEL 8 to not allow packet forwarding, unless the system is a router with the following commands: $ sudo sysctl -w net.ipv4.ip_forward=0 $ sudo sysctl -w net.ipv6.conf.all.forwarding=0 If "0" is not the system's default value then add or update the following lines in the appropriate file under "/etc/sysctl.d": net.ipv4.ip_forward=0 net.ipv6.conf.all.forwarding=0 |