Finding ID | Version | Rule ID | IA Controls | Severity |
---|---|---|---|---|
V-230543 | RHEL-08-040270 | SV-230543r599732_rule | Medium |
Description |
---|
ICMP redirect messages are used by routers to inform hosts that a more direct route exists for a particular destination. These messages contain information from the system's route table, possibly revealing portions of the network topology. There are notable differences between Internet Protocol version 4 (IPv4) and Internet Protocol version 6 (IPv6). There is only a directive to disable sending of IPv4 redirected packets. Refer to RFC4294 for an explanation of "IPv6 Node Requirements", which resulted in this difference between IPv4 and IPv6. |
STIG | Date |
---|---|
Red Hat Enterprise Linux 8 Security Technical Implementation Guide | 2020-11-25 |
Check Text ( C-33212r568375_chk ) |
---|
Verify RHEL 8 does not allow interfaces to perform Internet Protocol version 4 (IPv4) ICMP redirects by default. Note: If either IPv4 or IPv6 is disabled on the system, this requirement only applies to the active internet protocol version. Check the value of the "default send_redirects" variables with the following command: $ sudo sysctl net.ipv4.conf.default.send_redirects net.ipv4.conf.default.send_redirects=0 If the returned line does not have a value of "0", or a line is not returned, this is a finding. |
Fix Text (F-33187r568376_fix) |
---|
Configure RHEL 8 to not allow interfaces to perform Internet Protocol version 4 (IPv4) ICMP redirects by default with the following command: $ sudo sysctl -w net.ipv4.conf.default.send_redirects=0 If "0" is not the system's default value then add or update the following line in the appropriate file under "/etc/sysctl.d": net.ipv4.conf.default.send_redirects=0 |