A maximum of 60-minute delay must be specified for the password retry after 3 failed attempts to enter your password

Overview

Finding ID	Version	Rule ID	IA Controls	Severity
V-25404	HMC0135	SV-31588r1_rule	ECLO-1 ECLO-2	Low

Description
The Maximum failed attempts before disable delay is not set to 3. This specifies the number of consecutive incorrect password attempts the Hardware Management Console allows as 3 times, before setting a 60-minute delay to attempt to retry the password. The improper setting of any of these fields, individually or in combination with another, can compromise the security of the processing environment. Note: The Hardware Management Console does not allow a revoke of a user ID.A 60-minute delay time setting is being substituted.

Description

The Maximum failed attempts before disable delay is not set to 3. This specifies the number of consecutive incorrect password attempts the Hardware Management Console allows as 3 times, before setting a 60-minute delay to attempt to retry the password. The improper setting of any of these fields, individually or in combination with another, can compromise the security of the processing environment. Note: The Hardware Management Console does not allow a revoke of a user ID.A 60-minute delay time setting is being substituted.

STIG	Date
IBM Hardware Management Console (HMC) STIG	2015-01-14

Details

Check Text ( C-31864r1_chk )
Have the System Administrator display the Disable delay in minutes. Disable Delay is found in User Profiles by selecting the user, selecting modify user and then selecting User Properties. If this is les than 60 minutes then this is a finding. Note: Hardware Management Console does not have the ability to revoke a user ID, so a 60-minute delay has been imposed instead.

Fix Text (F-28357r1_fix)
The System Administrator will display the User Properties window on the Hardware Management Console for each user and verify that the disable delay is set to 60 or more. Maximum Failed Attempts and Disable Delay are found in User Profiles by selecting the user, selecting modify user and then selecting User Properties.