The Cisco perimeter switch must be configured to have Link Layer Discovery Protocol (LLDP) disabled on all external interfaces.

Overview

Finding ID	Version	Rule ID	IA Controls	Severity
V-221096	CISC-RT-000360	SV-221096r856650_rule		Low

Description
LLDP is a neighbor discovery protocol used to advertise device capabilities, configuration information, and device identity. LLDP is media-and-protocol-independent as it runs over layer 2; therefore, two network nodes that support different layer 3 protocols can still learn about each other. Allowing LLDP messages to reach external network nodes provides an attacker a method to obtain information of the network infrastructure that can be useful to plan an attack.

Description

LLDP is a neighbor discovery protocol used to advertise device capabilities, configuration information, and device identity. LLDP is media-and-protocol-independent as it runs over layer 2; therefore, two network nodes that support different layer 3 protocols can still learn about each other. Allowing LLDP messages to reach external network nodes provides an attacker a method to obtain information of the network infrastructure that can be useful to plan an attack.

STIG	Date
Cisco NX OS Switch RTR Security Technical Implementation Guide	2023-02-15

Details

Check Text ( C-22811r409777_chk )
Step 1: Verify LLDP is not enabled globally via the command feature lldp. By default the LLDP feature is not enabled. If LLDP is enabled, proceed to Step 2. Step 2: Verify LLDP is not enabled on any external interface as shown in the example below: interface Ethernet2/2 description link to DISN no switchport no lldp transmit Note: LLDP is enabled by default on all interfaces once it is enabled globally; hence the command lldp transmit will not be visible on the interface configuration. If LLDP transmit is enabled on any external interface, this is a finding.

Check Text ( C-22811r409777_chk )

Step 1: Verify LLDP is not enabled globally via the command feature lldp.

By default the LLDP feature is not enabled. If LLDP is enabled, proceed to Step 2.

Step 2: Verify LLDP is not enabled on any external interface as shown in the example below:

interface Ethernet2/2
description link to DISN
no switchport
no lldp transmit

Note: LLDP is enabled by default on all interfaces once it is enabled globally; hence the command lldp transmit will not be visible on the interface configuration.

If LLDP transmit is enabled on any external interface, this is a finding.

Fix Text (F-22800r409778_fix)
Disable LLDP transmit on all external interfaces as shown in the example below: SW2(config)# int e2/2 SW2(config-if)# no lldp transmit SW2(config-if)# end