The Cisco Multicast Source Discovery Protocol (MSDP) router must be configured to use a loopback address as the source address when originating MSDP traffic.

Overview

Finding ID	Version	Rule ID	IA Controls	Severity
V-216823	CISC-RT-000950	SV-216823r531087_rule		Low

Description
Using a loopback address as the source address offers a multitude of uses for security, access, management, and scalability of MSDP routers. It is easier to construct appropriate ingress filters for router management plane traffic destined to the network management subnet since the source addresses will be from the range used for loopback interfaces instead of a larger range of addresses used for physical interfaces. Log information recorded by authentication and syslog servers will record the router’s loopback address instead of the numerous physical interface addresses.

Description

Using a loopback address as the source address offers a multitude of uses for security, access, management, and scalability of MSDP routers. It is easier to construct appropriate ingress filters for router management plane traffic destined to the network management subnet since the source addresses will be from the range used for loopback interfaces instead of a larger range of addresses used for physical interfaces. Log information recorded by authentication and syslog servers will record the router’s loopback address instead of the numerous physical interface addresses.

STIG	Date
Cisco IOS XR Router RTR Security Technical Implementation Guide	2023-06-01

Details

Check Text ( C-18055r288843_chk )
Verify that the loopback interface is used as the source address for all MSDP packets generated by the router. router msdp connect-source Loopback0 If the router does not use its loopback address as the source address when originating MSDP traffic, this is a finding.

Fix Text (F-18053r288844_fix)
Configure the router to use its loopback address is used as the source address when sending MSDP packets. RP/0/0/CPU0:R2(config)#router msdp RP/0/0/CPU0:R2(config-msdp)#connect-source lo0 RP/0/0/CPU0:R2(config-msdp)#end