Changes are coming to https://stigviewer.com.
Take our survey to help us understand your usage and how we can better serve you in the future.
Take Survey
The Cisco perimeter switch must be configured to have Cisco Discovery Protocol (CDP) disabled on all external interfaces.
Overview
| Finding ID | Version | Rule ID | IA Controls | Severity |
|---|---|---|---|---|
| V-221017 | CISC-RT-000370 | SV-221017r856412_rule | Low |
| Description |
|---|
| CDP is a Cisco proprietary neighbor discovery protocol used to advertise device capabilities, configuration information, and device identity. CDP is media-and-protocol-independent as it runs over layer 2; therefore, two network nodes that support different layer 3 protocols can still learn about each other. Allowing CDP messages to reach external network nodes provides an attacker a method to obtain information of the network infrastructure that can be useful to plan an attack. |
| STIG | Date |
|---|---|
| Cisco IOS XE Switch RTR Security Technical Implementation Guide | 2023-02-28 |
Details
| Check Text ( C-22732r408845_chk ) |
|---|
| Step 1: Verify if CDP is enabled globally as shown below: cdp run By default, CDP is not enabled globally or on any interface. If CDP is enabled globally, proceed to Step 2. Step 2: Verify CDP is not enabled on any external interface as shown in the example below: interface GigabitEthernet2 ip address z.1.24.4 255.255.255.252 … … … cdp enable If CDP is enabled on any external interface, this is a finding. |
| Fix Text (F-22721r408846_fix) |
|---|
| Disable CDP on all external interfaces via no cdp enable command or disable CDP globally via no cdp run command. |