The Cisco switch must enable Unidirectional Link Detection (UDLD) to protect against one-way connections.

Overview

Finding ID	Version	Rule ID	IA Controls	Severity
V-220665	CISC-L2-000190	SV-220665r539671_rule		Medium

Description
In topologies where fiber optic interconnections are used, physical misconnections can occur that allow a link to appear to be up when there is a mismatched set of transmit/receive pairs. When such a physical misconfiguration occurs, protocols such as STP can cause network instability. UDLD is a layer 2 protocol that can detect these physical misconfigurations by verifying that traffic is flowing bidirectional between neighbors. Ports with UDLD enabled periodically transmit packets to neighbor devices. If the packets are not echoed back within a specific time frame, the link is flagged as unidirectional and the interface is shut down.

Description

In topologies where fiber optic interconnections are used, physical misconnections can occur that allow a link to appear to be up when there is a mismatched set of transmit/receive pairs. When such a physical misconfiguration occurs, protocols such as STP can cause network instability. UDLD is a layer 2 protocol that can detect these physical misconfigurations by verifying that traffic is flowing bidirectional between neighbors. Ports with UDLD enabled periodically transmit packets to neighbor devices. If the packets are not echoed back within a specific time frame, the link is flagged as unidirectional and the interface is shut down.

STIG	Date
Cisco IOS XE Switch L2S Security Technical Implementation Guide	2021-03-24

Details

Check Text ( C-22380r507543_chk )
If any of the switch ports have fiber optic interconnections with neighbors, review the switch configuration to verify that UDLD is enabled globally or on a per-interface basis as shown in the examples below: hostname SW2 … … … udld enable or interface GigabitEthernet0/1 udld port Note: An alternative implementation when UDLD is not supported by connected device is to deploy a single member Link Aggregation Group (LAG) via IEEE 802.3ad Link Aggregation Control Protocol (LACP). If the switch has fiber optic interconnections with neighbors and UDLD is not enabled, this is a finding.

Check Text ( C-22380r507543_chk )

If any of the switch ports have fiber optic interconnections with neighbors, review the switch configuration to verify that UDLD is enabled globally or on a per-interface basis as shown in the examples below:

hostname SW2
…
…
…
udld enable

or

interface GigabitEthernet0/1
udld port

Note: An alternative implementation when UDLD is not supported by connected device is to deploy a single member Link Aggregation Group (LAG) via IEEE 802.3ad Link Aggregation Control Protocol (LACP).

If the switch has fiber optic interconnections with neighbors and UDLD is not enabled, this is a finding.

Fix Text (F-22369r507544_fix)
Configure the switch to enable Unidirectional Link Detection (UDLD) to protect against one-way connections. SW2(config)#udld enable or SW2(config)#int g0/1 SW2(config-if)#udld port