The Cisco MPLS router must be configured to use its loopback address as the source address for LDP peering sessions.

Overview

Finding ID	Version	Rule ID	IA Controls	Severity
V-96967	CISC-RT-000590	SV-106105r1_rule		Low

Description
Using a loopback address as the source address offers a multitude of uses for security, access, management, and scalability of backbone routers. It is easier to construct appropriate ingress filters for router management plane traffic destined to the network management subnet since the source addresses will be from the range used for loopback interfaces instead of from a larger range of addresses used for physical interfaces. Log information recorded by authentication and syslog servers will record the router's loopback address instead of the numerous physical interface addresses.

Description

Using a loopback address as the source address offers a multitude of uses for security, access, management, and scalability of backbone routers. It is easier to construct appropriate ingress filters for router management plane traffic destined to the network management subnet since the source addresses will be from the range used for loopback interfaces instead of from a larger range of addresses used for physical interfaces. Log information recorded by authentication and syslog servers will record the router's loopback address instead of the numerous physical interface addresses.

STIG	Date
Cisco IOS XE Router RTR Security Technical Implementation Guide	2019-07-25

Details

Check Text ( C-95803r1_chk )
Review the router configuration to determine if it is compliant with this requirement. Verify that a loopback address has been configured as shown in the following example: interface Loopback0 ip address 10.1.1.1 255.255.255.255 By default, routers will use its loopback address for LDP peering. If an address has not be configured on the loopback interface, it will use its physical interface connecting to the LDP peer. If the router-id command is specified that overrides this default behavior, verify that it is a loopback interface as shown in the example below: mpls ldp router-id Loopback0 If the router is not configured to use its loopback address for LDP peering, this is a finding.

Check Text ( C-95803r1_chk )

Review the router configuration to determine if it is compliant with this requirement.

Verify that a loopback address has been configured as shown in the following example:

interface Loopback0
ip address 10.1.1.1 255.255.255.255

By default, routers will use its loopback address for LDP peering. If an address has not be configured on the loopback interface, it will use its physical interface connecting to the LDP peer. If the router-id command is specified that overrides this default behavior, verify that it is a loopback interface as shown in the example below:

mpls ldp router-id Loopback0

If the router is not configured to use its loopback address for LDP peering, this is a finding.

Fix Text (F-102647r1_fix)
Configure the router to use their loopback address as the source address for LDP peering sessions. As noted in the check content, the default behavior is to use its loopback address. R4(config)#mpls ldp router-id lo0