Changes are coming to https://stigviewer.com.
Take our survey to help us understand your usage and how we can better serve you in the future.
Take Survey
The Cisco perimeter switch must be configured to drop IPv6 packets containing a Hop-by-Hop header with invalid option type values.
Overview
| Finding ID | Version | Rule ID | IA Controls | Severity |
|---|---|---|---|---|
| V-237765 | CISC-RT-000394 | SV-237765r856667_rule | Medium |
| Description |
|---|
| These options are intended to be for the Destination Options header only. The optional and extensible natures of the IPv6 extension headers require higher scrutiny since many implementations do not always drop packets with headers that it cannot recognize and hence could cause a Denial-of-Service on the target device. In addition, the type, length, value (TLV) formatting provides the ability for headers to be very large. |
| STIG | Date |
|---|---|
| Cisco IOS Switch RTR Security Technical Implementation Guide | 2023-09-13 |
Details
| Check Text ( C-40978r856259_chk ) |
|---|
| This requirement is not applicable for the DODIN Backbone. Review the switch configuration to determine if it is compliant with this requirement. Step 1: Verify that an inbound IPv6 ACL has been configured on the external interface. interface gigabitethernet1/0 ipv6 address 2001::1:0:22/64 ipv6 traffic-filter FILTER_IPV6 in Step 2: Verify that the ACL drops IPv6 packets containing a Hop-by-Hop header with option type values of 0x04 (Tunnel Encapsulation Limit), 0xC9 (Home Address Destination), or 0xC3 (NSAP Address) as shown in the example below. ipv6 access-list FILTER_IPV6 deny hbh any any dest-option-type 4 log deny hbh any any dest-option-type 195 log deny hbh any any dest-option-type home-address log permit ipv6 … … … … deny ipv6 any any log If the switch is not configured to drop IPv6 packets containing a Hop-by-Hop header with invalid option type values, this is a finding. |
| Fix Text (F-40940r856260_fix) |
|---|
| Configure the switch to drop IPv6 packets containing a Hop-by-Hop header with invalid option type values as shown in the example below. SW1(config)#ipv6 access-list FILTER_IPV6 SW1(config-ipv6-acl)#deny hbh any any dest-option-type 4 log SW1(config-ipv6-acl)#deny hbh any any dest-option-type 195 log SW1(config-ipv6-acl)#deny hbh any any dest-option-type home-address log SW1(config-ipv6-acl)# permit ipv6 … … … … SW1(config-ipv6-acl)#deny ipv6 any any log SW1(config-ipv6-acl)#exit SW1(config)#int g1/0 SW1(config-if)#ipv6 traffic-filter FILTER_IPV6 SW1(config-if)#end |