Changes are coming to https://stigviewer.com.
Take our survey to help us understand your usage and how we can better serve you in the future.
Take Survey
The Cisco perimeter switch must be configured to deny network traffic by default and allow network traffic by exception.
Overview
| Finding ID | Version | Rule ID | IA Controls | Severity |
|---|---|---|---|---|
| V-220440 | CISC-RT-000240 | SV-220440r622190_rule | High |
| Description |
|---|
| A deny-all, permit-by-exception network communications traffic policy ensures that only connections that are essential and approved are allowed. This requirement applies to both inbound and outbound network communications traffic. All inbound and outbound traffic must be denied by default. Firewalls and perimeter switches should only allow traffic through that is explicitly permitted. The initial defense for the internal network is to block any traffic at the perimeter that is attempting to make a connection to a host residing on the internal network. In addition, allowing unknown or undesirable outbound traffic by the firewall or switch will establish a state that will permit the return of this undesirable traffic inbound. |
| STIG | Date |
|---|---|
| Cisco IOS Switch RTR Security Technical Implementation Guide | 2023-02-17 |
Details
| Check Text ( C-22155r508405_chk ) |
|---|
| Review the switch configuration to verify that the inbound access control list (ACL) applied to all external interfaces is configured to allow specific ports and protocols and deny all other traffic. Step 1: Verify that an inbound ACL is applied to all external interfaces as shown in the example below: interface GigabitEthernet0/2 ip address x.11.1.2 255.255.255.254 ip access-group EXTERNAL_ACL in Step 2: Review the inbound ACL to verify that it is configured to deny all other traffic that is not explicitly allowed. ip access-list extended EXTERNAL_ACL permit tcp any any established permit icmp host x.11.1.1 host x.11.1.2 echo permit icmp host x.11.1.1 host x.11.1.2 echo-reply … … … deny ip any any log-input If the ACL is not configured to allow specific ports and protocols and deny all other traffic, this is a finding. If the ACL is not configured inbound on all external interfaces, this is a finding. |
| Fix Text (F-22144r508406_fix) |
|---|
| Step 1: Configure an inbound ACL to deny all other traffic by default as shown in the example below: SW1(config)#ip access-list extended EXTERNAL_ACL SW1(config-ext-nacl)#permit tcp any any established SW1(config-ext-nacl)#permit icmp host x.11.1.1 host x.11.1.2 echo SW1(config-ext-nacl)#permit icmp host x.11.1.1 host x.11.1.2 echo-reply … … … SW1(config-ext-nacl)#deny ip any any log-input Step 2: Apply the ingress filter to all external interfaces. SW1(config)#int g0/2 SW1(config-if)#ip access-group EXTERNAL_ACL in |