UCF STIG Viewer Logo

The Cisco switch must be configured to use encryption for routing protocol authentication.


Overview

Finding ID Version Rule ID IA Controls Severity
V-220422 CISC-RT-000040 SV-220422r622190_rule Medium
Description
A rogue switch could send a fictitious routing update to convince a site's perimeter switch to send traffic to an incorrect or even a rogue destination. This diverted traffic could be analyzed to learn confidential information about the site's network or used to disrupt the network's ability to communicate with other networks. This is known as a "traffic attraction attack" and is prevented by configuring neighbor switch authentication for routing updates. However, using clear-text authentication provides little benefit since an attacker can intercept traffic and view the authentication key. This would allow the attacker to use the authentication key in an attack. This requirement applies to all IPv4 and IPv6 protocols that are used to exchange routing or packet forwarding information; this includes all Interior Gateway Protocols (such as OSPF, EIGRP, and IS-IS) and Exterior Gateway Protocols (such as BGP), MPLS-related protocols (such as LDP), and multicast-related protocols.
STIG Date
Cisco IOS Switch RTR Security Technical Implementation Guide 2021-03-19

Details

Check Text ( C-22137r508354_chk )
Review the switch configuration. For every routing protocol that affects the routing or forwarding tables, verify that the switch is encrypting the authentication key as shown in the examples below:

EIGRP example:

interface GigabitEthernet1/0
no switchport
ip address x.x.x.x 255.255.255.0
ip authentication mode eigrp 1 md5
ip authentication key-chain eigrp 1 EIGRP_KEY_CHAIN

OSPF example:

interface GigabitEthernet1/0
no switchport
ip address x.x.x.x 255.255.255.0
ip ospf authentication message-digest
ip ospf message-digest-key 1 md5 xxxxxx

RIP example:

interface GigabitEthernet1/0
no switchport
ip rip authentication mode md5
ip rip authentication key-chain RIP_KEY_CHAIN

If the routing protocol is not encrypting the authentication key, this is a finding.
Fix Text (F-22126r508355_fix)
Configure all routing protocol authentications to encrypt the authentication key.

EIGRP example:

SW2(config)#int g0/1
SW2(config-if)#ip authentication mode eigrp 1 md5
SW2(config-if)#ip authentication key-chain eigrp 1 EIGRP_KEY_CHAIN

OSPF example:

SW1(config)#int g1/0
SW1(config-if)#ip ospf authentication message-digest
SW1(config-if)#ip ospf message-digest-key 1 md5 xxxxxx

RIP example:

SW2(config)#int g1/0
SW2(config-if)#ip rip authentication mode md5
SW2(config-if)#ip rip authentication key-chain RIP_KEY_CHAIN