The Cisco multicast Rendezvous Point (RP) must be configured to rate limit the number of Protocol Independent Multicast (PIM) Register messages.

Overview

Finding ID	Version	Rule ID	IA Controls	Severity
V-96655	CISC-RT-000850	SV-105793r1_rule		Medium

Description
When a new source starts transmitting in a PIM Sparse Mode network, the DR will encapsulate the multicast packets into register messages and forward them to the RP using unicast. This process can be taxing on the CPU for both the DR and the RP if the source is running at a high data rate and there are many new sources starting at the same time. This scenario can potentially occur immediately after a network failover. The rate limit for the number of register messages should be set to a relatively low value based on the known number of multicast sources within the multicast domain.

Description

When a new source starts transmitting in a PIM Sparse Mode network, the DR will encapsulate the multicast packets into register messages and forward them to the RP using unicast. This process can be taxing on the CPU for both the DR and the RP if the source is running at a high data rate and there are many new sources starting at the same time. This scenario can potentially occur immediately after a network failover. The rate limit for the number of register messages should be set to a relatively low value based on the known number of multicast sources within the multicast domain.

STIG	Date
Cisco IOS Router RTR Security Technical Implementation Guide	2019-07-25

Details

Check Text ( C-95491r1_chk )
Review the configuration of the RP to verify that it is rate limiting the number of PIM register messages. ip pim rp-address 10.2.2.2 ip pim register-rate-limit nn If the RP is not limiting PIM register messages, this is a finding.

Fix Text (F-102329r1_fix)
Configure the RP to rate limit the number of multicast register messages. R2(config)#ip pim register-rate-limit nn