The Cisco BGP switch must be configured to enable the Generalized TTL Security Mechanism (GTSM).

Overview

Finding ID	Version	Rule ID	IA Controls	Severity
V-221021	CISC-RT-000470	SV-221021r856414_rule		Low

Description

As described in RFC 3682, GTSM is designed to protect a switch's IP-based control plane from DoS attacks. Many attacks focused on CPU load and line-card overload can be prevented by implementing GTSM on all Exterior Border Gateway Protocol-speaking switches. GTSM is based on the fact that the vast majority of control plane peering is established between adjacent switches; that is, the Exterior Border Gateway Protocol peers are either between connecting interfaces or between loopback interfaces. Since TTL spoofing is considered nearly impossible, a mechanism based on an expected TTL value provides a simple and reasonably robust defense from infrastructure attacks based on forged control plane traffic.

STIG	Date
Cisco IOS-XE Switch RTR Security Technical Implementation Guide	2022-09-13

Details

Check Text ( C-22736r408857_chk )

Review the BGP configuration to verify that TTL security has been configured for each external neighbor as shown in the example below: router bgp xx no synchronization bgp log-neighbor-changes neighbor x.1.1.9 remote-as yy neighbor x.1.1.9 password xxxxxxxx neighbor x.1.1.9 ttl-security hops 1 neighbor x.2.1.7 remote-as zz neighbor x.2.1.7 password xxxxxxxx neighbor x.2.1.7 ttl-security hops 1 If the switch is not configured to use GTSM for all Exterior Border Gateway Protocol peering sessions, this is a finding.

Fix Text (F-22725r408858_fix)
Configure TTL security on all external BGP neighbors as shown in the example below: SW1(config)#router bgp xx SW1(config-switch)#neighbor x.1.1.9 ttl-security hops 1 SW1(config-switch)#neighbor x.2.1.7 ttl-security hops 1