The Cisco switch must be configured to implement message authentication for all control plane protocols.
Overview
| Finding ID | Version | Rule ID | IA Controls | Severity |
|---|---|---|---|---|
| V-220987 | CISC-RT-000020 | SV-220987r856398_rule | Medium |
| Description |
|---|
| A rogue switch could send a fictitious routing update to convince a site's perimeter switch to send traffic to an incorrect or even a rogue destination. This diverted traffic could be analyzed to learn confidential information about the site's network, or used to disrupt the network's ability to communicate with other networks. This is known as a "traffic attraction attack" and is prevented by configuring neighbor switch authentication for routing updates. This requirement applies to all IPv4 and IPv6 protocols that are used to exchange routing or packet forwarding information; this includes all Interior Gateway Protocols (such as OSPF, EIGRP, and IS-IS) and Exterior Gateway Protocols (such as BGP), MPLS-related protocols (such as LDP), and multicast-related protocols. |
| STIG | Date |
|---|---|
| Cisco IOS-XE Switch RTR Security Technical Implementation Guide | 2022-09-13 |
Details
| Check Text ( C-22702r408755_chk ) |
|---|
| Review the switch configuration. Verify that authentication is enabled for all routing protocols. The configuration examples below depicts OSPF, EIGRP, IS-IS and BGP authentication. BGP Example: router bgp nn no synchronization bgp log-neighbor-changes neighbor x.x.x.x remote-as nn neighbor x.x.x.x password xxxxxxx EIGRP Example: key chain EIGRP_KEY key 1 key-string xxxxxxx … … … interface GigabitEthernet0/0 no switchport ip address x.x.x.x 255.255.255.0 ip authentication mode eigrp 1 md5 ip authentication key-chain eigrp 1 EIGRP_KEY IS-IS Example: interface GigabitEthernet0/0 no switchport ip address x.x.x.x 255.255.255.0 ip router isis isis password xxxxxxx OSPF Example: interface GigabitEthernet0/0 no switchport ip address x.x.x.x 255.255.255.0 ip ospf authentication-key xxxxx If authentication is not enabled on all routing protocols, this is a finding. |
| Fix Text (F-22691r408756_fix) |
|---|
| Configure authentication to be enabled for every protocol that affects the routing or forwarding tables. The example configuration commands below enables OSPF, EIGRP, IS-IS, and BGP authentication. BGP Example: SW1(config)#router bgp nn SW1(config-switch)#neighbor x.x.x.x password xxxxxx EIGRP Example: SW1(config)#key chain EIGRP_KEY SW1(config-keychain)#key 1 SW1(config-keychain-key)#key-string xxxxx SW1(config-keychain-key)#exit SW1(config-keychain)#exit SW1(config)#int g0/0 SW1(config-if)#ip authentication mode eigrp 1 md5 SW1(config-if)#ip authentication key-chain eigrp 1 EIGRP_KEY SW1(config-if)#end IS-IS Example: SW1(config)#int g0/0 SW1(config-if)#isis password xxxxxx OSPF Example: SW1(config)#int g0/0 SW1(config-if)#ip ospf authentication-key xxxxx SW1(config-if)#end |