The Cisco perimeter switch must be configured to have Link Layer Discovery Protocol (LLDP) disabled on all external interfaces.

Overview

Finding ID	Version	Rule ID	IA Controls	Severity
V-101749	CISC-RT-000360	SV-110853r1_rule		Low

Description
LLDP is a neighbor discovery protocol used to advertise device capabilities, configuration information, and device identity. LLDP is media-and-protocol-independent as it runs over layer 2; therefore, two network nodes that support different layer 3 protocols can still learn about each other. Allowing LLDP messages to reach external network nodes provides an attacker a method to obtain information of the network infrastructure that can be useful to plan an attack.

Description

LLDP is a neighbor discovery protocol used to advertise device capabilities, configuration information, and device identity. LLDP is media-and-protocol-independent as it runs over layer 2; therefore, two network nodes that support different layer 3 protocols can still learn about each other. Allowing LLDP messages to reach external network nodes provides an attacker a method to obtain information of the network infrastructure that can be useful to plan an attack.

STIG	Date
Cisco IOS-XE Switch RTR Security Technical Implementation Guide	2020-05-20

Details

Check Text ( C-100637r1_chk )
Step 1: Verify LLDP is not enabled globally via the command. lldp run By default LLDP is not enabled globally. If LLDP is enabled, proceed to Step 2. Step 2: Verify LLDP is not enabled on any external interface as shown in the example below: interface GigabitEthernet0/1 ip address x.1.12.1 255.255.255.252 no lldp transmit Note: LLDP is enabled by default on all interfaces once it is enabled globally; hence the command "lldp transmit" will not be visible on the interface configuration. If LLDP transmit is enabled on any external interface, this is a finding.

Check Text ( C-100637r1_chk )

Step 1: Verify LLDP is not enabled globally via the command.

lldp run

By default LLDP is not enabled globally. If LLDP is enabled, proceed to Step 2.

Step 2: Verify LLDP is not enabled on any external interface as shown in the example below:

interface GigabitEthernet0/1
ip address x.1.12.1 255.255.255.252
no lldp transmit

Note: LLDP is enabled by default on all interfaces once it is enabled globally; hence the command "lldp transmit" will not be visible on the interface configuration.

If LLDP transmit is enabled on any external interface, this is a finding.

Fix Text (F-107433r1_fix)
Disable LLDP transmit on all external interfaces as shown in the example below: SW1(config)#int g0/1 SW1(config-if)#no lldp transmit