The Cisco ASA must be configured to enable threat detection to mitigate risks of denial-of-service (DoS) attacks.

Overview

Finding ID	Version	Rule ID	IA Controls	Severity
V-239860	CASA-FW-000150	SV-239860r863229_rule		Medium

Description
A firewall experiencing a DoS attack will not be able to handle production traffic load. The high utilization and CPU caused by a DoS attack will also have an effect on control keep-alives and timers used for neighbor peering, resulting in route flapping and will eventually black-hole production traffic. The device must be configured to contain and limit a DoS attack's effect on the device's resource utilization. The use of redundant components and load balancing are examples of mitigating "flood-type" DoS attacks through increased capacity.

Description

A firewall experiencing a DoS attack will not be able to handle production traffic load. The high utilization and CPU caused by a DoS attack will also have an effect on control keep-alives and timers used for neighbor peering, resulting in route flapping and will eventually black-hole production traffic. The device must be configured to contain and limit a DoS attack's effect on the device's resource utilization. The use of redundant components and load balancing are examples of mitigating "flood-type" DoS attacks through increased capacity.

STIG	Date
Cisco ASA Firewall Security Technical Implementation Guide	2023-02-13

Details

Check Text ( C-43093r863228_chk )
NOTE: When operating the ASA in multi-context mode with a separate IDPS, threat detection cannot be enabled, and this check is Not Applicable. Review the ASA configuration to determine if threat detection has been enabled. threat-detection basic-threat If the ASA has not been configured to enable threat detection to mitigate risks of DoS attacks, this is a finding.

Fix Text (F-43052r665865_fix)
Configure threat detection as shown in the example below. ASA(config)# threat-detection basic-threat